How to Make Things With Birch Bark

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • Scissors

  • Birch bark

  • Craft knife

  • Ultra-fine tip permanent marker

  • Tape measure or yardstick

  • 4-inch diameter plastic or glass cylindrical vase, 8 inches tall

  • Hot glue sticks

  • Hot glue gun

Make decorative items from pieces of birch bark.

Birch bark peels from the tree in large pieces or sheets. Dead birch trees disintegrate quickly, leaving behind sections of birch bark that are round and up to several feet long. The bark is very strong and you can use it to create such things as decorative leaves, vases and a small canoe that floats. Each project takes approximately 15 minutes to make. Learn the process to work with birch bark, then experiment with other designs.

Advertisement

Birch Bark Leaves

Step 1

Draw the shapes of maple, oak and ash leaves at least 3 inches long on a piece of paper. Cut out the paper shapes and use them as templates.

Video of the Day

Step 2

Turn a piece of birch bark over so the front is on the bottom. Trace around the paper leaf templates.

Step 3

Cut along the traced line with a craft knife. Push firmly to cut through the thickness of the birch bark.

Step 4

Flip the leaves over so the front of the birch bark is facing up.

Step 5

Draw a center vein and several small leaf veins on the surface of the birch bark leaves with an ultra-fine tip permanent marker.

Advertisement

Birch Bark Vase

Step 1

Measure and cut a piece of birch bark 8 inches tall and 13 inches long. Flip the birch bark so the front side is on the bottom and the long edges are horizontal.

Step 2

Place a 4-inch diameter cylindrical vase that is 8 inches tall on its side. Line the vase up with the top, bottom and one side edge of the cut birch bark.

Advertisement

Step 3

Roll the bark around the outside edge of the vase.

Step 4

Squeeze a line of hot glue along the seam.

Step 5

Continue to roll the birch bark tightly around the vase so the final edge is attached to the line of hot glue.

Advertisement

Birch Bark Model Canoe

Step 1

Place a piece of birch bark on a flat work surface so the front side of the bark is facing down. Measure, mark and cut a 3-by-5-inch rectangle from the birch bark.

Step 2

Turn the rectangle so the two 3-inch ends are horizontal. Draw a V shape connecting the top left-hand corner and the top right-hand corner that is 1 inch deep. Repeat the process with the bottom left-hand and bottom right-hand corner. Cut the V shapes from the birch bark.

Advertisement

Step 3

Flip the birch bark over so the front side is on top. Squeeze a line of glue along one edge of the V shape cut in the top of the rectangle. Pull the opposite edge of the V shape across the glue until the cut edges for the top of the canoe are even. Repeat the process with the remaining V shape.

Step 4

Hot glue or cut any birch bark overlap that is not glued together.

Advertisement

Video of the Day

references