How to Fix Bowed-Out Walls

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • Stud finder

  • Pencil

  • Pry bar

  • Hammer

  • Drywall panel

  • Utility knife

  • Measuring tape

  • Cordless screwdriver

  • Drywall screws

  • Joint tape

  • Joint compound

  • Drywall knife

Replacing the drywall is the only way to fix a bowed wall.
Image Credit: Jupiterimages/Photos.com/Getty Images

A bowed wall is typically caused by either a poor drywall installation technique or by drywall that has gotten wet and lost its shape. Although drywall is a very hard surface, if it gets wet, it degrades and warps. If the drywall wasn't hung and taped properly, it may also change shape and bow outward. This type of problem is fixed by removing the bowed section and replacing it with new drywall.

Advertisement

Step 1

Find the wall studs near the bowed section with a stud finder. This helps you locate the seams of the bowed panel for easy removal. Mark this spot with a pencil.

Video of the Day

Step 2

Pry off the old drywall with a pry bar. Insert the end of the pry bar through the drywall on top of your pencil marks and pry out. This should pop the drywall off of its nails or screws. Continue until the entire section is removed.

Step 3

Remove the nails or screws left behind in the wood studs. If the old panel was nailed, flip your hammer around and pry the nails out. Place them in a small bucket to keep them contained. If screws were used, reverse the direction of your cordless screwdriver and remove them.

Step 4

Cut the new drywall to fit the area with a utility knife. Measure out the space that is now open. Make cut lines using these dimensions on the back of the drywall panel with a pencil. Score on top of the cut lines with a utility knife. Snap the drywall to break it. Cut through the paper with the utility knife.

Advertisement

Step 5

Hang the drywall in place with a cordless screwdriver and drywall screws. Fit the new drywall panel into the empty space. Drive screws through the drywall into the wall studs. Use one screw for every 12 inches on the vertical. The screw heads should just dimple the paper of the drywall.

Step 6

Tape the seams of the drywall patch with joint tape. Use self-adhesive tape to eliminate having to mud before applying the tape. Press down firmly to create a good seal.

Advertisement

Step 7

Apply joint compound over the tape and the screw dimples with a drywall knife. The tape should be entirely covered with joint compound. Apply a 1/4-inch-thick coat over the tape and the dimple marks. Scrape off the excess compound with the edge of the drywall knife. Let the compound harden for four to six hours.

Step 8

Sand the joint compound smooth with a fine-grit sanding block. The surface of the drywall panel should be smooth to the touch and level.

Advertisement

Video of the Day

references