How to Make Multiple Electrical Cords Into One Cord

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • Utility knife

  • Wire cutters

  • Soldering iron

  • Solder

  • Hair dryer

  • Electrical cord with the plug attached

  • ¼-inch heat-shrink tubing

  • ½-inch heat-shrink tubing

  • Electrical tape

When stringing multiple extension cords together is not a viable option for an electrical cord, you can always wire multiple electrical cords together to make one long cord. The benefit of having one cord is that you will not need multiple extension cords or adapters to extend a power cord to reach an electrical outlet. You can make multiple electrical cords into one cord by learning how to splice them together.

Advertisement

Step 1

Cut the plug end off the power cord that needs to be extended or made longer. Cut the opposite end off the cord that still has the plug to remove any frayed ends.

Video of the Day

Step 2

Place the two cords on a flat surface, such as a table, so they lie end to end with one on the left and one on the right.

Advertisement

Step 3

Place a 6-inch section of ½-inch heat-shrink tubing over one piece of electrical cord. This will be used to go over the completed splice.

Step 4

Remove about four inches of the outer jacket from each cord. A utility knife or wire cutters can be used to remove the outer jacket.

Advertisement

Step 5

Splice the wire together at different places to keep the splices separated.

Step 6

Remove the insulation covering the wires from the cord on the left. Cut 2 inches away from the jacket for the hot wire and 3 inches for the neutral wire. Do not cut the ground wire.

Advertisement

Step 7

Remove insulation covering the wires from the cord on the right. Cut 3 inches away from the jacket for the neutral wire and 2 inches away from the jacket for the ground wire. Do not cut the hot wire.

Step 8

Strip each wire 1 inch using a pair of wire cutters.

Advertisement

Step 9

Cut the ¼-inch heat-shrink tubing in three 1½-inch pieces and place over the ends of the exposed wires on one section of cord.

Step 10

Join the stripped wires together by crossing the wires in the middle and twisting them together.

Advertisement

Step 11

Solder the wires together using the soldering iron and then place the heat shrink tubing over the splice. Shrink the tubing using a hair dryer or soldering iron. Repeat this process for each wire until all wires have been sliced together.

Step 12

Place the ½-inch heat-shrink tubing over the splice and shrink it using a hair dryer or the soldering iron.

Step 13

Wrap electrical tape over the splice to complete the project.

Tip

Each splice will be separated by 1 inch to keep enough insulation between the bare wires.

The process for splicing a two-wire cord is the same as for the three-wire cord.

Repeat this process if you need to connect more than two electrical cords.

Warning

You can only splice a two-wire cord to a two-wire cord or a three-wire cord to a three-wire cord.

If the wires are not soldered properly, they will not conduct electricity correctly.

Advertisement

Video of the Day

references