How to Make a Free Standing Mailbox

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • 4-by-4 lumber

  • 1-inch-thick board

  • Mailbox

  • Tape measure

  • Wood glue

  • Paint or stain

  • Power drill

  • Small drill bit

  • Wood screws

  • Power saw

  • Hammer

  • Chisel

  • 5-gallon bucket

  • Gravel or potting soil

Making a freestanding mailbox is relatively simple. You can do it with basic tools and a minimal investment of time and money. One advantage of a freestanding mailbox is that if it is hit by a vehicle or snowplow, it will likely suffer little or no damage and can simply be placed back upright. A mailbox post sunk into the ground would likely snap off, making repairs more difficult.

Advertisement

Building a Freestanding Mailbox

Step 1

Check guidelines with the U.S. Postal Service prior to building your mailbox. Regulations require the bottom of the mailbox be 41-45 inches above the road's surface. The mailbox door must be 6-8 inches from the front of the curb or road edge. Contact your local post office before moving your mailbox.

Video of the Day

Step 2

Build a mailbox stand made of treated 4-by-4 lumber. Cut one board 57 inches long. Cut the other 36 inches long.

Step 3

Measure your mailbox. Allow an extra inch of clearance, and mark the 36-inch board accordingly. For example, if your mailbox is 20 inches long, mark the board at 21 inches. Put another mark 3.5 inches beyond the first mark to accommodate the width of the other 4-by-4 (a 4-by-4 actually measures 3.5 inches square).

Advertisement

Step 4

Cut between the two marked lines to a depth of 1.75 inches (half the width of a 4-by-4). Remove the waste wood with multiple cuts from a power saw, or with a hand chisel and hammer.

Step 5

Measure the 57-inch board. Mark it at 41 inches and again at 44.5 inches. Remove the wood in between the marks to a depth of 1.75 inches.

Advertisement

Step 6

Dry fit the two boards together. Remove additional wood as needed until the boards fit together snugly. When they fit, glue them together with exterior-grade wood glue. Let dry. Stain or paint the 4-by-4s.

Step 7

Measure the underside of your mailbox. Cut a 1-inch-thick board so it fits just inside the mailbox bottom. Screw the board to the 4-by-4 mailbox support arm. Set the mailbox on the 1-inch board and screw the mailbox to the board through the holes in the side of the mailbox.

Advertisement

Step 8

Obtain a 5-gallon bucket or antique milk can. Drill multiple small holes in the bottom to allow water to drain. The holes must be smaller than the gravel that will be used for fill.

Step 9

Place the mailbox post in the center of the bucket. Pour in fine gravel until the bucket or can is nearly full. You could substitute potting soil for the gravel and then plant flowers inside.

Step 10

Place the mailbox the required distance from the road or curb.

Tip

A flower planter box can be placed on the backside of the mailbox support arm.

Advertisement

Video of the Day

references