How to Replace GFI With a Regular Breaker

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • Safety glasses

  • Electrical gloves

  • Screwdriver

Replacing a GFI or GFCI, also known as ground fault interrupt or ground fault circuit interrupt, breaker is a lot like changing a normal circuit breaker, with a couple of exceptions. The main difference is that normal circuit breakers do not have neutral wires to attach to the breaker's main buss bar. With the proper planning and attention to safety, nearly anyone can replace a GFI breaker with a normal one.

Advertisement

Step 1

Put your safety glasses and electrical gloves on.

Video of the Day

Step 2

Open the breaker box's main door. This may require the removal of one or more screws depending on the design of your breaker box.

Step 3

Locate the main power switch and disengage it into the "Off" or "Open" position.

Step 4

Locate the specific GFI breaker you wish to replace.

Step 5

Locate the white wire coming from the GFI circuit breaker you wish to replace and follow it to the mounting point on the breaker box's buss bar.

Advertisement

Step 6

Locate the screw holding the exposed end of the white wire in place and loosen it to allow for removal of the wire.

Step 7

Remove the white wire from the buss bar by pulling it out of the mounting hole.

Advertisement

Step 8

Locate the black wire that is connected to the GFI breaker you wish to remove.

Step 9

Unscrew the screw holding the black wire in place and pull out the wire.

Step 10

Pull out the GFI breaker. This may require some effort as these breakers are held in place by friction.

Advertisement

Step 11

Insert the normal breaker into the now open breaker slot. Make sure it is off before putting it in place.

Step 12

Insert the black wire underneath the mounting screw on the normal breaker. This screw will hold the wire in place in the same manner the GFI breaker did.

Advertisement

Step 13

Tighten the screw to allow for a firm hold on the black wire. Do not over tighten the screw so much that the wire is forced out from underneath the screw's head.

Step 14

Engage the normal breaker into the "On" or "Open" position.

Advertisement

Step 15

Engage the main breaker power switch into the "On" or "Open" position.

Step 16

Close the breaker box and replace any screws previously removed.

Warning

Even with the main power switch off, there are large amounts of electrical current within a breaker box. Always ensure you know exactly what you are doing and that you are doing it in the safest manner possible. If at any time you are unsure of yourself while performing this procedure, seek the advice of an electrician.

Advertisement

Video of the Day

references