How to Build a Nut Oil Press

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • Plate steel

  • 3-ton cylinder jack

  • 1.75-inch metal tubing

  • Angle iron

  • Steel bar

  • Arc welder

  • Bandsaw

  • Drill press

  • Filter

  • Plastic jug

  • Carbide blade

  • 6-inch diameter Metal canister

  • 1-inch screws

  • Wooden board 24 inches wide and 24 inches long

  • Paint

  • File

  • Grinder

A pile of nuts becomes tasty cooking oil with a press you build.

Oils extracted from nuts, such as peanut oil, can be used in the same way as other vegetable oils for frying and as a baking ingredient. Although nut oils are available in stores, processed and packaged products usually include a number of added ingredients. To cook with pure nut oil, it is possible to press your own at home. Oil presses can squeeze the oil from ground nuts or ground seeds. Building such a press requires some welding ability and a significant investment of time.

Advertisement

Step 1

Purchase a standard cylindrical 3-ton hydraulic jack from an auto-parts store. This has a handle that is pumped by hand to raise a central cylinder with up to 3 tons of force; this force will squeeze the oil from the ground nuts.

Video of the Day

Step 2

Mount a carbide blade onto a bandsaw or circular saw and use it to cut two 24.5-inch lengths and one 6.5-inch length of 1.75-inch diameter steel tubing. The carbide blade is the only type that will not dull while cutting the metal of the tube.

Step 3

Cut a 5.5-inch piece of steel bar and two 8-inch lengths of angle iron (which has two faces at a 90-degree angle), again using a carbide-blade saw.

Step 4

Use an arc welder to weld all the metal pieces into a rectangular frame. Stand the two long metal tubes on their ends 5.5 inches apart, with the shorter metal tube on its end midway between them. Weld the piece of metal bar across the top of the two long tubes, and the two pieces of angle iron on either side of the bottom of the three tubes together.

Advertisement

Step 5

Use a file and a grinder to remove any rough surfaces from the cuts and welds, then paint the whole thing to seal in any metal shavings and dust that might get into the oil being pressed. Once the paint dries, attach the whole frame to a piece of wood by drilling holes into the angle iron and passing screws through them into the wood.

Advertisement

Step 6

Weld one end of a steel canister shut with a metal disk cut from your piece of plate steel, then drill 15 to 20 holes distributed around the canister's sides toward the closed end. This will be the pressing cylinder, with the holes allowing the oil to escape.

Step 7

Build the piston that fits into the press cylinder by welding a metal disk to the end of a short length of pipe. The pipe should be just large enough to fit over the small pipe in the middle of your frame, while the disk should be cut to fit snugly inside the press canister.

Advertisement

Step 8

Slice off the bottom 1.5 inches of a round plastic jug and cut a hole in the center big enough for the small pipe at the center of the frame. Slide this piece over the small pipe, where it will serve as a collection tray for the oil dripping from the canister.

Step 9

Set the piston disk on top of the small middle pipe. Pile up ground nuts on top of it, then cover the pile with the press canister.

Advertisement

Step 10

Fit the 3-ton jack in between the top of the canister and the top of the frame, with the jack piston centered on the top of the canister. Pump the jack using the attached handle. As the piston presses the canister down onto the ground nuts, it will squeeze out the oil, which will escape from the holes in the sides of the canister and drip into the collection tray at the bottom.

Advertisement

Video of the Day

references