How to Strip the Zinc Plating From Bolts

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

To protect bolts from rust, manufacturers add zinc plating. This coating is shiny and may stand out on construction projects that are attempting to re-create an aged or rustic appearance. Removing zinc plating requires the use of hydrochloric acid, which can be purchased as muriatic acid — a highly corrosive agent that reacts readily with the zinc plating. Before purchasing muriatic acid, contact your local water company or hazardous waste disposal company for proper solution disposal procedures. A working muriatic acid solution should be a 1:10 dilution of acid to water.

Advertisement

The shine on new bolts comes from zinc plating.

Video of the Day

Things You'll Need

  • 3 Gallon Bucket

  • Glass Measuring Cup, Pyrex If Available

  • Muriatic Acid

  • Mask

  • Gloves

  • Steel Tongs

  • 5 Gallon Bucket

  • Zinc-Plated Bolts

  • 1 Pound Sodium Bicarbonate (Baking Soda)

  • Goggles Or Other Protective Eyewear

  • Water

Stripping Zinc Plating with a Muriatic Acid Solution

Step 1

Calculate the ratio of muriatic acid to water. A gallon of liquid equals 16 cups. For a gallon solution of 1:10 ratio of muriatic acid to water you need 1.6 cups of muriatic acid and 14.4 cups of water. Do not mix more than a gallon of solution at a time. The greater the volume of the solution, the harder it will be to neutralize later.

Video of the Day

Step 2

Place all of your materials in a well-ventilated area, preferably outside.

Step 3

Put on protective gloves, mask and eyewear before preparing the solution.

Step 4

Add the water to a 3 gallon bucket.

Advertisement

Step 5

Add the muriatic acid to the bucket. Always add acid to water. Adding water into acid creates an exothermic reaction that will produce enough heat to melt the bucket.

Step 6

Use the steel tongs to carefully place the zinc bolts into the solution. The bolts will fizz in contact with the solution, releasing hydrogen gas.

Advertisement

Neutralizing the Bolts and Muriatic Acid Solution

Step 1

Fill the 5 gallon bucket half full with water. The amount does not have to be exact.

Step 2

Add baking soda to the water while stirring. Add enough baking soda that a thin film of precipitate remains on the bottom.

Advertisement

Step 3

Use the steel tongs to remove the bolts from the bucket and place them in the neutralization solution.

Step 4

Allow the zinc-plated bolts to sit for two to three minutes or until any noticeable chemical reaction has ceased.

Advertisement

Step 5

Remove the bolts from the neutralization bucket and flush with a garden hose or under a faucet for at least five minutes to remove all traces of muriatic acid.

Step 6

Pour the muriatic solution into the neutralization bucket slowly. Be careful not to splash the solution on clothing or exposed skin.

Step 7

Add additional sodium bicarbonate to the neutralization solution if it continues to fizz.

Tip

Use only industrial grade plastic buckets. Do not use household mop buckets since the plastic will be too thin and may react with the muriatic acid.

Warning

Exercise extreme caution when using muriatic acid. Do not dump excess muriatic acid or the neutralization solution into local water supplies or your yard without authorization.

Advertisement

references & resources