How to Cast Cultured Marble

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • Plastic mold designed for resin casting

  • Mold release (if necessary)

  • Two-part casting resin

  • Marble powder

  • Clean, flat-bottom container

  • Stirring stick

  • Hair drier

The use of marble powder and casting resin produces castings that look like polished marble.

Cultured marble is polymer resin mixed with marble dust or other whitening agent, such as calcium carbonate. Casting cultured marble involves how much of the additive you want to use; if you're casting a figure with fine detail, too much additive will prevent the resin from filling all the small voids in the mold. If, on the other hand, you're casting a simple shape like a column, using plenty of stone additive will give you the look of real polished stone.

Advertisement

Step 1

Apply mold release to the mold if recommended by the manufacturer. Urethane, latex and silicone molds typically require mold release when used with casting resin.

Video of the Day

Step 2

Measure both parts of the casting resin into a clean mixing container as directed by the manufacturer. Many casting resins are combined in a 1-to-1 ratio, but some use small amounts of hardener added to a much larger quantity of resin.

Advertisement

Step 3

Mix the two parts of the resin together thoroughly for two minutes or as suggested by the manufacturer. Scrape down the sides and stir contents up from the bottom with the stirring stick.

Step 4

Stir marble powder into the resin a little at a time until you reach the desired color and consistency. Mixtures for highly detailed molds should be liquidy; mixtures for simple shapes can be much thicker, up to the consistency of peanut butter.

Advertisement

Step 5

Pour the resin mix into the mold, a little at a time. If the mix is thick, gently agitate the mix in the mold after each pour to settle the mix into the mold.

Step 6

Lightly heat the exterior of the mold with a hair drier to prompt bubbles to rise to the surface.

Advertisement

Step 7

Allow the resin to fully cure for 72 hours at room temperature.

Step 8

Remove the casting from the mold. If the mold is rigid, twist the casting slightly to free it. If the mold is flexible, carefully peel it away from the casting.

Tip

Several colors of marble powder are available as casting mixtures. You can also use granite, copper and brass powders to create the look of granite or metal sculptures. If you need a fairly liquid casting mixture, you can whiten the resin before adding the marble powder; this will give you the desired color without having to add a high proportion of solids to the mix.

Warning

Most casting resins emit harmful vapors; do your casting in an area with good ventilation. Be careful when heating the mold; high temperatures can melt some flexible molds. Do not attempt to remove the casting for 24 hours after pouring the resin or you will damage the casting. Resins with powders mixed into them tend to produce bubbles, which can ruin the casting if they form at the surface of the casting. Be careful to work slowly and gently to heat the mold to remove bubbles before the resin cures.

Advertisement

Video of the Day

references & resources