How to Add a Zone to a Sprinkler System

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • New sprinkler valve

  • PVC primer

  • PVC glue

  • PVC supply pipe

  • Sprinkler control wire

  • Wire caps

Adding a sprinkler zone can increase water coverage.

Adding a zone to an existing sprinkler system can allow you to cover more turf with the proper amount of water by reducing demand on other zones. Adding a new zone requires a sprinkler control box that's capable of expanding zones, as well as a new sprinkler valve that is added to the existing manifold control unit. This project takes about two hours to do properly.

Advertisement

Adding a Valve

Step 1

Turn off the supply line to the sprinkler manifold. There is usually a control valve near the manifold control box.

Video of the Day

Step 2

Locate the sprinkler manifold. It's usually in an irrigation box buried underground with an exposed lid.

Step 3

Remove the cap from the end of the existing manifold. This is where you will add a new control valve.

Step 4

Apply a thin layer of PVC primer to the inside of the manifold tube where you just removed the cap. Follow that by applying a thin layer of PVC glue over the primer.

Advertisement

Step 5

Insert a short length (about 5 inches) of PVC pipe that's the same diameter as the existing tube into the primed and glued opening.

Step 6

On the other end of the short PVC pipe, apply a thin layer of primer and glue to the outside of the pipe, about one inch around the end.

Advertisement

Step 7

Press one end of the control valve into the glued pipe. This will connect the valve to the existing system.

Step 8

Apply PVC primer and glue to one end of a PVC supply line and quickly press the pipe into the other side of the valve. This line will take water from the valve to your new zone.

Advertisement

Step 9

Continue connecting lengths of supply pipe until you reach the desired location for your new zone.

Connecting the Control Timer

Step 1

Locate the control timer and remove the cover to expose the wiring diagram.

Advertisement

Step 2

Identify an open zone port that is available to connect a new zone to. Each zone requires a positive and negative connection, so an open port should have two metal clamps or screws that do not have any wires attached.

Step 3

Connect two sprinkler control wires to each connector in the open port by clamping them into place or tightening the set screws. Note which color wire is attached to the negative and positive sides of the port.

Advertisement

Step 4

Run the wire to the sprinkler manifold box.

Step 5

Attach the sprinkler control wires to the new valve's exposed wire. Place the positive wire from the control timer to the wire marked "positive" on the valve. Connect the wires with a wire cap.

Step 6

Turn on the sprinkler water supply.

Tip

Test the new zone by selecting the port that you connected the wiring to from the control timer and running for five minutes.

Advertisement

Video of the Day

references