How to Replace a Belt on a Scotts S1742 Lawn Mower

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Scotts S1642, S1742 and S2046 are all submodels built under the Scotts brand name by John Deere. Essentially, these models are John Deere tractors and mowers without the trademark John Deere logo or green and yellow paint scheme. Just as standard John Deere lawn mowers utilize a suspended deck and drive belt system, Scotts mowers have the same equipment. When the drive belt stretches beyond the point where the mower deck can compensate, you must replace the belt with a new one or risk having the belt break, which would leave the mower deck disabled.

Advertisement

Step 1

Drive your Scotts S1742 mower onto level, stable ground and set the parking brake.

Video of the Day

Step 2

Disengage the PTO, or blade, lever to stop the blades from rotating. Disengaging the PTO lever also creates additional slack in the drive belt.

Advertisement

Step 3

Raise the adjustment lever for the mower deck to position the deck as high off the ground as possible. Slide two-by-fours under the front and back of the deck or under the left and right side of the deck. Lower the deck onto the blocks to take tension off the suspension rods.

Step 4

Remove the cotter pins from the suspension rods. Pull the washers and the suspension rods off the rod pins. Lower the suspension rods into a horizontal position.

Advertisement

Step 5

Locate the drive pulley mounted under the Scotts mower and pull the drive belt off the pulley.

Step 6

Remove the deck from the two-by-fours and slide the deck out.

Step 7

Remove the belt from the Scotts mower deck. If needed, make a note of how the belts route before you take the belt off. Place the new belt on the deck.

Advertisement

Step 8

Slide the deck under the Scotts tractor, then place the deck back on the two-by-fours.

Step 9

Place the belt over the pulley mounted under the engine.

Step 10

Line the suspension rods up with the rod pins. Slide the washers over the pins, then secure them with the cotter pins.

Step 11

Remove the two-by-fours from under the deck. Lower the deck to its normal cutting height.

Video of the Day

Advertisement

references